Questions About Fixing A Car...

[Vtghost]

Ok So I Am Thinking About Picking Up Another G20 P10 And It Needs A Cv Joint And I Was Wondering How Hard It Would Be To Put One In.. Also It Needs A New Ignition Switch..But I Was Wondering If I Took The Ignition Switch Out Of My P10 And Put It In The One I Wanted To Fix Up If It Would Work?

Also Can You Tell Exactly Were The Cv Joint Is?
Is It The Driveshaft?

[MaximusG20]

CV ball joints? Or the CV axles which are connected to the tranny?

[Wiggy]

cv joints aren't to bad they are a little involved but with the correct tools they are easily replaced, the hardest thing about doing a joint is removing the axle nut (its torqued to 190ft lbs or more so make sure you have a breaker bar when taking it off)

the ignition switch should be pretty easy to get to, simply remove the plastic cover on the column and locate the wires and take off the switch, you can probably get one at autozone or checkers for less than 40 bucks


good luck

joe

[Vtghost]

I Guess Its The Axle...How Much Will A New Axle Run Me??

Also Will I Be Able To Swap The Ignition Switch From any G20 As Long As iIHave The Key To That Ignition?

[Vtghost]

Ok I Found An Cv Axle For $70 But I Am Still Stuck With What To Do With The Ignition....

[Greenless]

as long as its not a chipped key i dont see why you couldnt change the ignition. but i will be a pian in the ass. but i could be wrong im no pro so dont take my word


where did you find the axle that cheap? is it reman or just used?

[Vtghost]

hmmm does anyone know or have an idea of how much it would cost to put a new one in?

[MaximusG20]

hmmm does anyone know or have an idea of how much it would cost to put a new one in?

My peeps usually do this kind of job between $30-$50. Assuming you're talking about the axle?