i bought a 99 g20t the guy claimed he installed a 91 se-r cam i checked timing its sitting between positive 13 and 15 degrees i checked alldata and thats correct timing for stock i was curious if anyone else had this issue my car is a automatic. oops my bad its a lil sluggish at normal acceleration just wondering if anyone does a different degree of timing. i dont have problems with my other 99 g20t automatic and i dont have any pending codes or dtcs
Last edited by 801P11; Jul 09, 12 at 06:41 PM.
What issue?
oops my bad its a lil sluggish at normal acceleration just wondering if anyone does a different degree of timing. i dont have problems with my other 99 g20t automatic and i dont have any pending codes or dtcs
well try play with distributor a little bit, and what plugs are you running? part number
you should not have to play with the distributor. the cam will run fine at stock ignition timeing. also I have installed a 91 intake cam in a 99 g20 for a member and he claimed but dyno gains. car went on the dyno after the install so not sure on real gains. he also had a auto. also during the intake cam install one does not move the distributor at all.
did you scan the ecu for codes even though the light is not on?
No codes none pending either i think the cat is pluged plugs wires cap and rotor are fineOriginally Posted by p10det
Posting Permissions
Reply With Quote