COMING SOON TO A SOCAL GEE NEAR YOU!!!!!!!!!
My VE Build
Bottom End 86MM
Stock VE Pistons & Rings Wrist Pin's
ACL Bearings All of them
Castillo's Worked Crankshaft
Knife Edge, Detail Balance, Drill + Tap Plugs
Port & Polished Head (Port Matched)
N1 Intake Manifold & TB (Port Matched by Andreas Miko)
Franklin 20V/N1 Cams
BC titanium Springs and Retainers
ASP Budget Header with 2.5 inch Exhaust
Place Racing WAI and E60 MAF
370CC OEM Injectors
Thanks Final Speed Garage & Gspec !!!!!!!!!!!!!!!!!!
Last edited by LerkZone; Jan 06, 12 at 09:18 AM.
Youre selling the car Frank?
->My WTB thread for El Chacal<-
SR20DEEP CA César D
rims lookin good
NICE!!!!! i like the C2s on your car moar than the 5 spokes mang
ENGINE SR20VE PORN Castillo Crankshaft
that heavy ass shit must weigh less then a 4cw crank now. Shaved a shit load off
HEY DON WE HOMIES.
It's a STATEMENT, not a question.
Uhh, that IS a 4cw.
Last edited by LerkZone; Jan 27, 12 at 03:15 PM.
Yes Rods, Pistons Check
Last edited by LerkZone; Jan 27, 12 at 11:07 AM.
Let me drive it!
AZ 1/2 Race G20'S_TEAM NIZMO_AZG'Z
Over compensating with those rods?
I only like 3 p10's
yours is one of them
wicked vtakkk. hope to see her on wcm3
It's about time Frank!
Perry Infiniti Parts Department - Escondido, CA
Direct Phone 760-294-7082