nah man i was but i decided just to keep it and fix it up
nah man i was but i decided just to keep it and fix it up
ohh ic. make sure u have all the stuff needed before u tear apart your car for turbo
only been a week without her running and i miss her already
![]()
Did you replace the retainer clips on the T/O bearing?
they have about 5k miles on them now. shud i replace them before i put in the new tranny?
Just check them. Make sure they're not cracked or split or broken or anything else possibly bad.
Looking great Ivanathan
My new tranny sitting in the garage waiting to be put in
While i was pulling the tranny off i needed a break bar and forgot mine at home so i used the jdm two piece handle on the wheel barrow
Also one more thing, i talked to two people about this but i thought mabe id post it up anyway. Mabe some else can chime in. The tranny looks as if mabe it leaked on the bottom but im still thinking it could be from when they drained the fluids it got wet and dirt just got stuck onto to from the bottom but just to be sure i was thining about opening the tranny and re-sealing it again while its out. Question is, can i open it knowing nothin will fall out or get outa place?
savage....those wheels look great. i love them so much.
Mikayla's honorable mentions:
IPUTINWORK - G20/Equips / ILOVEDRIVINGSLOW - Fresh Gee20 / JUSTSTANCE - THAT G20
Cleaned up the tranny a little and while my battery was outa the car i went and got a new one for free(warranty ftw)
From This
To This
New Battery
And While I Was Out I Decided To Snap A Pic Of Her
![]()
is that a cinnamin dolce latte with 3 splenda and soy milk? cause thats what it looks like from here.
Mikayla's honorable mentions:
IPUTINWORK - G20/Equips / ILOVEDRIVINGSLOW - Fresh Gee20 / JUSTSTANCE - THAT G20
Mikayla's honorable mentions:
IPUTINWORK - G20/Equips / ILOVEDRIVINGSLOW - Fresh Gee20 / JUSTSTANCE - THAT G20
I doubt the case on the tranny was leaking. It was probably a couple of things, like the shift linkage input shaft arm and the axle seals with the drain bolt. I'd replace those. If you do split the case do it with the gear set pointing up and the gears will stay in place.