|
|
Sep 20, 07, 03:20 PM
|
#1 |
|
G20 Senior Member
|
Sr20ve w/N1 Cams and keeping stock springs and retainers OK?
I have a Ve motor and was just wondering if this is a safe route. I will be getting N1 cams but do not plan on switching out my retainers and springs.
I am running a DE ecu so I could only rev up to 7500K..Ive read that this set up will be safe if I dont pass 8k rpm's... What do you think? My de motor was still good and it had 278k hope the same for the VE 
__________________
91 p10 ..my primera has 262,000 miles now. salamat~gracias~laterz (p10=beater car) my p10 is not only an old car, its an old friend that i cant get rid of! Don't Hate just FORNICATE!  my race vid! Last edited by p10socal; Sep 20, 07 at 03:25 PM. |
|
|
|
Sep 22, 07, 12:54 PM
|
#2 |
|
G20 Senior Member
|
I found the answer.
It is safe to keep stock Ve retainers and springs as long as you do not exceed 8500k rpm's...be careful and do not over rev or set rpm's at 8k..
__________________
91 p10 ..my primera has 262,000 miles now. salamat~gracias~laterz (p10=beater car) my p10 is not only an old car, its an old friend that i cant get rid of! Don't Hate just FORNICATE! my race vid! |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
