Sr20ve w/N1 Cams and keeping stock springs and retainers OK? - G20.net

p10socal · Sep 20, 07, 02:20 PM

I have a Ve motor and was just wondering if this is a safe route. I will be getting N1 cams but do not plan on switching out my retainers and springs.

I am running a DE ecu so I could only rev up to 7500K..Ive read that this set up will be safe if I dont pass 8k rpm's...

What do you think? My de motor was still good and it had 278k hope the same for the VE

p10socal · Sep 22, 07, 11:54 AM

I found the answer.

It is safe to keep stock Ve retainers and springs as long as you do not exceed 8500k rpm's...be careful and do not over rev or set rpm's at 8k..

Sep 20, 07, 02:20 PM	#1
p10socal G20 Senior Member Feedback: (1) (100%) Join Date: Apr 2002 Location: San Diego Posts: 555 Vehicle: p10	Sr20ve w/N1 Cams and keeping stock springs and retainers OK? I have a Ve motor and was just wondering if this is a safe route. I will be getting N1 cams but do not plan on switching out my retainers and springs. I am running a DE ecu so I could only rev up to 7500K..Ive read that this set up will be safe if I dont pass 8k rpm's... What do you think? My de motor was still good and it had 278k hope the same for the VE Last edited by p10socal; Sep 20, 07 at 02:25 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Sep 22, 07, 11:54 AM	#2
p10socal G20 Senior Member Feedback: (1) (100%) Join Date: Apr 2002 Location: San Diego Posts: 555 Vehicle: p10	I found the answer. It is safe to keep stock Ve retainers and springs as long as you do not exceed 8500k rpm's...be careful and do not over rev or set rpm's at 8k..