Infiniti G20 Nissan Primera Forum banner
1 - 17 of 17 Posts

·
Registered
Joined
·
82 Posts
Discussion Starter · #1 · (Edited)
I'm looking for a few small things to complete my P10.

Fog Lights/brackets and button. I'm also possibly looking to grab the OEM spoiler. Also if anyone is local (since shipping would be to much of a hassle) cream leather interior, specifically the bottom half of the back seat.

Looking for a FSTB and perhaps a RSTB as well

Might be adding more to this later as I clean the car and look for more stuff I'll need.
 

·
CH0DEmobile
Joined
·
3,202 Posts
The sticky console can be cleaned with rubbing alcohol to remove the mess. I've done this on a few P10s. It takes a little bit of elbow grease and a few paper towels, but it's cheaper/easier than buying a new one!
 

·
Registered
Joined
·
82 Posts
Discussion Starter · #3 ·
The sticky console can be cleaned with rubbing alcohol to remove the mess. I've done this on a few P10s. It takes a little bit of elbow grease and a few paper towels, but it's cheaper/easier than buying a new one!
Lol i just figured this out the other night. I went through all kind of products and rubbing alcohol seemed to help. Still kinda tacky but after the rubbing alcohol wipes it off i put some Simoniz Vinyl protectant on it which seemed to smooth it up a bit. I didn the bottom of the dash part, but the ebrake surround piece is giving me hell...I need to pick up some more elbow grease, what a pain!
 

·
CH0DEmobile
Joined
·
3,202 Posts
Lol i just figured this out the other night. I went through all kind of products and rubbing alcohol seemed to help. Still kinda tacky but after the rubbing alcohol wipes it off i put some Simoniz Vinyl protectant on it which seemed to smooth it up a bit. I didn the bottom of the dash part, but the ebrake surround piece is giving me hell...I need to pick up some more elbow grease, what a pain!
Yep, lots of elbow grease and paper towels! I found that one of those rough green scrubbing sponges works pretty well, just try a small area first to see if it scratches the plastic under the sticky mess.
 

·
Registered
Joined
·
13,217 Posts
I now happen to have a pair of p10 foglights WITH brackets and foglight switch from Phoenix, AZ

At this moment they are sitting in my parents garage in Phoenix but they are driving back with our parts next weekend so at that time I was planning to photograph and list 'em FS. The brackets are pristine (aka 100% rust free) obviously since they are from rust-free phoenix ;)
 
1 - 17 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top