Infiniti G20 Nissan Primera Forum banner
1 - 20 of 21 Posts

·
Registered
Joined
·
1,444 Posts
Discussion Starter · #1 · (Edited)
I suppose no one wants one anymore?

It's the factory "Nismo" Die-Cast one. Some people say it's not Nismo and just Nissan, most people call it "the Nismo one" so I'm calling it that.
$200 plus shipping OBO. I paid over $300 shipped for my own a few months ago.



That's the one, but that's not my pic. I'll put up pics of mine when I get a chance.
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter · #4 ·
Jesus, why am I selling it so cheap? I better make it $200 plus shipping, because I don't even know what shipping is going to cost. I've been burned by "oh yeah, probably about 20 bucks" before.
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter · #5 ·

·
Registered
Joined
·
1,444 Posts
Discussion Starter · #10 ·

·
Registered
Joined
·
1,444 Posts
Discussion Starter · #14 ·
Would u trade for a jdm steel front strut bar, since u already have two?
Sorry, need money. Sitting on about $4500 in inventory here. :/
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter · #16 ·
are these better then cusco or carbing?
I don't think any are necessarily better than the other...this thing is BEEFY AS HELL though, so if beefiness = better, then yes, it's better.
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter · #18 ·
Does it require any modifications (for clearance) to the hood or engine to install?
I don't think so. It had better not, because I have this for myself too. Maybe I'll try a quick test fit over my bolts and see how tight it is.
 

·
Registered
Joined
·
1,444 Posts
Discussion Starter · #19 ·
FYI for everyone, it clears a GTiR engine just fine.
 
1 - 20 of 21 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top