Infiniti G20 Nissan Primera Forum banner

P10 Inter cooler piping ?

1682 Views 6 Replies 5 Participants Last post by  SR
Hey guys,

I am currently tying to piece together my inter cooler piping, but before i buy any piping and couplers i would like to know if anyone can advise on the piping that would be needed for the project.

Such as
How many 90 degrees bends should i buy ?
How many 45 degrees bends ?
How many 70 degrees bends ?

Things like that, i have done a search but no one listed what they used. Intercooling pipes are a bit expensive so i really dont want to buy and waste unnecessary piping.

Any advice would be great.
1 - 7 of 7 Posts
i say just do 2' intercooler piping , i used if i remember 2 90's 2 45s.
You really have to mock things up and of get an idea of the set up you wish to run to get you started.

If you want to know best angles that seem to fit in cuitian spots and with low port are high port stuff that may help yeah good idea
it also all depends on how you want to run it. There are a few different ways

Id go to the diameter of your intercooler or intake manifold
Just buy U bends and cut as needed.
Are just buy straight pipe and pie cut all your own bends out like I did on the pipes you can see on my daily
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top