Infiniti G20 Nissan Primera Forum banner
1 - 14 of 14 Posts

·
Registered
Joined
·
444 Posts
woah...hellovadeal! Very interested. I have a little cash in my back pocket, but also need front struts and a LCA rebuild pretty badly too...decisions, decisions... Can you measure the length and width of the muffler itself? Want to make sure it will tuck up behind the bumper.

Does anyone have any input on this can? I want a nice tone, but nothing terribly loud or droning at freeway speeds.
 

·
Registered
Joined
·
0 Posts
Discussion Starter · #6 ·
I'll take some measurements today. You just need the can measurement or the entire muffler? Also, I'm taking the axle back piece off since it won't fit your G. Unless you want to pay a lil extra for shipping. The quote was without that extra 2 feet of piping.
 

·
Registered
Joined
·
444 Posts
I just want the measurements of the can, the tip should not be an issue.

Also, yeah, I would just cut the piping off and fab up my own from the flange to the can anyway, so its fine by me to save on shipping by removing it before you box it up. I have no use for it.

Thanks!
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top